15
4.6
Inserting the access control / photo ID card
The front of the tag has been designed to incorporate access control or photo ID cards.
Access control cards with the built in DESFire EV technology family are specifically
designed to fit inside the iTAG X-Range. These photo ID cards are available from
Extronics. The pop out card design enables cards to be printed on a standard ID card
printer, such as Matica and Magicard printers.
A DESFire EV1 or EV3 RFID Cards / Blank Photo ID card is shown in Figure 17.
Figure 17.
Once the RFID / Photo ID card has been printed and the Kiss cut area has been
removed, the card is ready to be installed into the iTAG.
Unscrew the captive screw located between the battery charging connecter pins using
a T8 Torx screwdriver and remove the clear photo ID cover, Figure 18.
Figure 18.
Insert the RFID / Photo ID card, Figure 19. If using the Blank Photo ID card with a
iCLASS HID RFID tag then stick the iCLASS HID tag to the iTAG or the ID card prior
to inserting the card.
Kiss cut area
