extronics iRFID101, Инструкция по установке и эксплуатации

Страница: 16 / 26

iRFID101 Installation and Operating Manual
16
3.8 External Overcurrent Protection
The iRFID101 should be installed on a circuit with a double-pole circuit breaker of a
maximum of 25A. This is the maximum current rating of the smallest internal chassis earth
bond in accordance with EN60950-1 2.6.3.3. Refer to Extronics if it becomes necessary to
exceed this rating.
3.9 Data Connections
3.9.1 Copper Ethernet
Information Check that the line speed of the switch port to which the
iRFID101 is connected matches the iRFID101 port
configuration, otherwise communication may not be
established.
If Copper Ethernet is specified, this will be terminated in a standard CAT5E RJ45 Socket on
the front plate of the iRFID101, Position D in Figure . Typically the interface will be an IEEE
10/100/1000BaseT format, but this is dependent on the access point installed.
Terminate the RJ45 plug as follows (EIA 568B standard):
3.9.2 Power-Over-Ethernet (POE)
If Power-Over-Ethernet (POE) is used, the format will depend on the access point installed
in the iRFID101. Ensure that the correct Power Sourcing Equipment (PSE) is used. Connect
the RJ45 cable per Section 3.9.1.
3.9.3 Optical Fibre
Warning! Optical radiation hazards may be present within the iRFID101
enclosure – observe the warning labels fitted.
Important Ensure that only the correct fibre transceiver format/power is
connected to the iRFID101. Damage to the iRFID101 fibre
interface or customer equipment may occur if the wrong
format/excessive optical power is used.
Figure 9: RJ45 CAT5E EIA 568B Plug Wiring