Extron electronics XTP SR HDMI, Руководство пользователя

Страница: 10 / 54

XTP SR HDMI Scaling Receiver • Installation 4
Installation
This section contains installation procedures for the XTP SR HDMI and wiring details. Topics
in this section include:
•
Rear Panel Connectors
• Connection Details
The XTP SR HDMI can be placed on a tabletop or mounted in a rack or under a desk (see
Mounting on page 47).
Rear Panel Connectors
LAN
SIG LINK
XTP IN
POWER
12V
HDMI
1.0 A MAX
Rx G Tx
RS-232 IR
Rx Tx
− + − +
L R 1 2
OVER XTP
AUDIO
OFF
ON
S/PDIF
RESET
RS-232
Tx Rx G
REMOTE RELAYS OUTPUTS
AUDIO
I A B C D E F G
H
A
XTP input connector (see page 4)
B
LAN connector (see page 5)
C
RS-232 and IR Over XTP connector
(see page 5)
D
HDMI output connector (see page 5)
E
Analog audio output connector
(see page 6)
F
S/PDIF audio output connector
(see page 6)
G
Relay connectors (see page 6)
H
Remote RS-232 connector
(see page 6)
I
Power connector and LED
(see page 6)
Figure 2. XTP SR HDMI Rear Panel Connectors
A
XTP input connector — Connect a twisted pair cable to the RJ-45 connector labeled
XTP IN
on the XTP SR HDMI and the XTP output port on another XTP device to pass
all signals (see TP Cable Termination and Recommendations on page 8). This
cable carries the following signals:
•
Digital video
•
Digital audio
•
Bidirectional RS-232 and IR commands
•
Remote power
•
Ethernet communication
•
System communication
Signal LED indicator — Lights green when the XTP SR HDMI receives an
active XTP input signal from a compatible transmitter or matrix switcher.
Link LED indicator — Lights yellow when a valid XTP link is established.
Signal Link