Extron • VTG 150 & VTG 200 • User’s Manual
Extron • VTG 150 & VTG 200 • User’s Manual
Application Information
Page 4-10
Figure 4-9A
The VTG 150 or the VTG 200 can be used to help isolate
problems within complex switcher configurations such as the
one pictured below.
OUTPUT
Application Information
Page 4-9
90-240 VAC, 50/60 Hz
FUSE: 250V, 400mA SLO-BLO
Figure 4-9A
Using the VTG 150 to test a switcher.
Troubleshooting
The VTG can be used for presentation system troubleshooting.
It can be placed in any part of the system to simulate a
computer signal. For example, if your system consists of a
projector, switcher and several computers, and the picture is
not coming up correctly on the projector, the VTG can be
connected at different points in the system, such as:
•
When a distribution amplifier is being used, the VTG can be
connected as an input source to test the amplifier's outputs.
•
Connect the VTG to the input of an interface, and the output of
the interface to a display device, thereby testing the interface.
•
The VGA and Mac outputs can be used to test analog
interfaces.
•
The 9-pin output can be used to test TTL interfaces.
•
Connect it to the projector’s input to test whether the projector
is operating properly with the computer input. (See fig. 4-9A.)
•
Connect it to the switcher’s inputs to test if all the inputs are
working properly and a signal passes through. (See fig. 4-9A.)
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
