Speaker test sequence
To run an automatic test sequence
1.
Select the
Auto
button. This sends a
two second test signal to each output
channel in the sequence shown in the
diagram at right. All other speakers
are muted. The test sequence cycles
through each speaker multiple times
until the test signal is switched off.
2.
Click on
Off
in the Select Signal Type
area to switch off the test signal and
end the test sequence.
To test the speakers manually:
1.
Click
Auto
to deselect it.
2.
Click the forward (
>
) or back (
<
) buttons to move forward or backward
through the sequence shown in the diagram below.
3.
Click
Off
in the Select Signal Type area to switch off the test signal and
end the test sequence.
Left Front
channel
Center
channel
Right Front
channel
Right Surround
channel
Left Surround
channel
Subwoofer
Center Back
channel
Right Back
channel
Left Back
channel
2 Sec
2 Sec
2 Sec
2 Sec
2 Sec
2 Sec
2 Sec
2 Sec
2 Sec
2 Sec
2 Sec
5.1 Setup
6.1 Setup
7.1 Setup
SSP 7.1 • Setup and Control Software
38
Содержание SSP 7.1
Страница 1: ...68 1339 01 Rev B 06 10 7 1 Channel Surround Sound Processor SSP 7 1 User Guide Audio ...
Страница 4: ......