NOTE:
Each of the four locking arm screws uses an Opti-Torque
TM
indicator ring.
The indicator releases a red plastic ring onto the screwdriver once the screw is
tightened to the correct torque. Stop tightening when this occurs to avoid
overtightening the locking arms to the C-ring.
8Ω
8Ω
64W
32W
OF
F
8W
16W
64W 32W 16W
OF
F
100 V
70
V
Figure 11.
Stop Tightening When the Red Fing Falls
Tightening the locking arms into soft material:
Because fiberglass ceilings and other soft materials are not as rigid as mineral tiles and
other hard materials, the Opti-Torque indicator ring must not to be used as a tightening
guide due to the risk of overtightening.
ATTENTION:
•
To avoid damaging or deforming soft ceiling material, tighten the locking arms
to secure the speaker, but stop tightening short of causing the speaker to
deform the flat mounting surface of the ceiling, as seen from below.
•
Afin de ne pas endommager ni d’altérer un plafond souple, serrez les bras de
verrouillage pour sécuriser l’enceinte, en veillant cependant à ce que l’unité ne
cause l’altération de la surface de montage plane du plafond, comme illustré
ci-dessous.
3.
If required, attach a secondary support line.
a.
Connect a secondary support line to the support loop on the back of the speaker
enclosure, as shown here.
Anchor the end to suitable
secure points within the
solid and permanent
building structure.
Figure 12.
Connecting a Secondary Support Line
X
SF 26CT LP User Guide • Installation - Single Installer
10
Содержание SoundField XD SF 26CT LP
Страница 6: ...SF 26CT LP User Guide Contents vi...