4
SMK V SB 33 Kit • Setup Guide (Continued)
9.
Adjust the SB 33 vertically as needed:
a.
Loosen, but do not remove, the bolts that attach the long L-brackets to the display.
TO
P
DIS
PLA
Y
(REA
R)
Vertical Adjustment
Long
L-bracket
Bolt
VESA Display
Mount
Washer
Figure 6.
Adjusting the SB 33 Speaker Wall Plate
b.
Adjust the SB 33 to the desired distance from the display, then tighten the bolts.
NOTE:
Assuming that the display screen is level, allow for some space
between the bottom of the display screen and the top of the speaker,
because the speaker assemblies and the center bracket attach to the
wallplate by hooking the top mounting clasps of the speaker assemblies
and center bracket over the top mounting rail of the wall plate (see the
diagram at right).
To allow sufficient clearance between the top of the SB 33 A and the
display screen above it, leave at least 0.69 inches (17.5 mm) between
the highest part of the top rail of the wallplate and the top of the speaker,
as shown at right. The display screen should not encroach into this area
above the top rail.
10.
Install the SB 33 A speaker to the wallplate. If the alignment between the display and the SB 33 speaker needs to be
adjusted, see
Aligning the SB 33 Speaker to the Display
.
TO
P
DIS
PL
AY
(REAR
)
DISPLA
Y
(REAR)
Wallplate
Short
L-bracket
Long
L-bracket
SB 33 A Speaker
Display
Figure 7.
Installing the SB 33 Speaker Wallplate
6
INPUTS
POWER
MA
X
12V
0.7A
OUTPUT
REMOTE
V
L
L
R
LEVE
L
BASS
TREBLE
R
CG
10V
50m
A
CLASS 2 WIRING
L SPEAKER
Wallplate
Side View
11/16"
(17.46 mm)
Wall
7
