Extron electronics PowerCage FOX Rx AV, Руководство пользователя

Страница: 46 / 48

Installing the FOX Tx/Rx AV Board in the PowerCage 1600 Enclosure
Up to 16 single slot or 8 dual slot boards can be inserted into the PowerCage enclosure.
The boards may vary with each installation depending on the configuration and use.
NOTES:
All boards are “hot-swappable,” meaning that they can be installed
or removed without turning off or disconnecting the power to the
PowerCage Enclosure.
Use ESD precautions when installing the FOX 3G HD-SDI board to avoid
damaging it. Keep the board in the anti-static bag until it is needed. Use
proper grounding techniques during installation.
1
2
REMO
TE
RS-232
RS-232
O
VER FIBER Tx Rx
Tx
ALARM
Rx
VIDE
O
PowerCage
FOX Tx AV
Tx Rx
L
R
A
UDIO
1
2
REMO
TE
RS-232
RS-232
O
VER FIBER Tx Rx
Tx
ALARM
Rx
VIDE
O
Y/VID
R-Y
B-Y/C
S-VID
PowerCage
FOX Rx AV
Tx Rx
L
R
A
UDIO
Y/VID R-Y
B-Y/C S-VID
Figure 29. PowerCage FOX TX/RX AV Boards
Inserting the Board into the Slot
1. Hold the board with the signal connectors towards you and the LED at the top, and
align the top and bottom grooves of the board with the slide posts in the selected
enclosure slot.
2.
Carefully slide the board into the slot, aligning the two tabs on the lower front end of
the board with the matching ports in the enclosure.
3.
Push the board firmly into place. Tighten the screws to secure the board in position.
NOTE:
In addition to the 16 single board slots (8 dual board slots) are 2 dual slots that
are reserved for power supplies only. The PowerCage 1600 comes with a dual
slot power supply board already installed, but an optional redundant power
supply board may be added using
only the dual slot position immediately
adjacent to the existing power supply. See the illustration on the next page.
PowerCage FOX Tx/Rx AV • Reference Information 40