Command/response table for SIS commands (continued)
Command
ASCII Command
(host to unit)
Response
(unit to host)
Additional description
Information requests
Information request
I
1Link
Y1(
•2link
Y1(
•RGB
Y1(
•Aud
Y1(
•
Y2)
•
Y2!]
The unit responds with the current status (signal
detected) of optical link 1, optical link 2, the
video input, and the audio link; the the fiber optic
transmission mode (singlemode or multimode); and
the device type (Tx or Rx).
NOTE:
The receiver monitors the primary (transmitter-TX to receiver-Rx) fiber cable. If the PC is connected to the transmitter and the
receiver-Tx-to-transmitter-Rx fiber cable is not connected, for the
I
and
1S
commands, the transmitter reports
1link0
regardless
of the status of the primary cable.
Show firmware version
Q
Y2@]
Example:
Q
1.23
]
The factory-installed firmware version is 1.23
(sample value only).
Request part number
N
60-
nnn
-
nn
]
Request part number of
other unit
1N
60-
nnn
-
nn
]
Show link 1 status
1S
Y1(]
Light status on transmitter-Tx-to-receiver-Rx cable.
Show link 2 status
2S
Y1(]
Light status on receiver-Tx-to-transmitter-Rx cable.
Show input video status
3S
Y1(]
Show transmitter video input status.
Show input audio status
4S
Y1(]
Show transmitter audio input status.
Show temperature
20S
Y2#]
Show temperature in degrees Fahrenheit and Celsius.
Resets
Reset audio
EZA
}
Zpa
]
Reset audio setting to default levels (0 dB gain).
Reset memory presets
EZG
}
Zpg
]
Reset (erase) all memory presets.
System reset
EZXXX
}
Zpx
]
Reset all settings to factory defaults.
NOTE:
Y1(
= Link status
0 = light or signal input not detected
1 = light or signal detected
Y2)
= Transmission mode
SM = singlemode
MM = multimode
Y2!
= Transmitter or receiver
Tx = transmitter
Rx = receiver
Y2@
= Firmware version
v
.
vv
Y2#
= Internal temperature
nnn
F•
nn
C
PowerCage FOX 4G DVI and PowerCage FOX 4G VGA • Remote Control
23
