MTP T 15HD A Architectural Series • Installation
10
Rear Panel Features
With the exceptions of
d
,
e
, and
f
on the MTP T 15HD A D
, as noted in the figures
and descriptions below, the rear panel features are the same on all the MTP T 15HD A
architectural models.
50
ON
OFF
60
Hz
PRE-
PEAK
EDID
SELECT
6
3
5
4
2
1
2
3
6
1
Figure 10.
MTP T 15HD WM and AAP (Left) and MTP T 15HD A D (Right)
Rear Panel Features
a
Output connector
— Connect one end of a twisted pair cable to this RJ-45 female
connector on the transmitter. Connect the free end of the same twisted pair cable to the
RJ-45 connector of the receiver. See “
Twisted Pair Cable Termination
” on page
13
to
wire the RJ-45 connectors.
b
Pre-Peak switch
— The Pre-Peak DIP switch boosts the video signal output to correct
for long cable runs. See the
table
on page
2
for suggested switch settings based on the
transmitted video format and transmission distance.
c
Stereo Audio output connector
— Insert bare wires into this direct insertion 3.5 mm,
5-pole captive screw audio connector for stereo audio outputs. Wire the connector as
shown in figure
11
.
Do not tin the wires!
Balanced Audio Output
Tip
Ring
Tip
Ring
Sleeves
Unbalanced Audio Output
Tip
No Ground Here
No Ground Here
Tip
Sleeves
LR
LR
ATTENTION:
Potential damage to property.
For unbalanced audio, connect the
sleeve(s) to the ground contact.
DO NOT
connect the sleeve(s) to
the negative (
-
) contacts.
Figure 11.
Captive Screw Audio Connector Wiring
