Extron electronics ISS 608, Руководство по установке

Страница: 2 / 6

2
ISS 608 • Setup Guide (Continued)
Step 5 — Connect Control Devices
• LAN (Ethernet) connector — (Optional) Connect a network WAN or LAN switch, a control system, or computer to the
Ethernet RJ-45 port (see figure 1 , G on page 1).
Defaults:
• IP address: 192.168.254.254 • Subnet: 255.255.0.0 • Gateway: 0.0.0.0 • DHCP: Off
See
Front Panel Controls
on page 4 to view or change the settings.
•
Remote RS-232 connector
— (Optional) Connect a control system or computer to the rear panel bidirectional RS-232 serial
port (see
figure 1
,
H
). The default baud rate is 9600.
• USB Config connector — (Optional) Connect a computer to the front panel USB mini-B port (see figure 4, F ).
Step 6 — Power
AC power connector — Connect a 100 to 240 VAC, 50 - 60 Hz power source to the AC power connector (see figure 1 ,
A
).
Power Up
Apply power by connecting
the power cord to an AC
source. The switcher performs
a self-test that displays the
model name and the firmware
version in the LCD screen.
After approximately 2 seconds,
the LCD screen reverts to its
default display cycle, alternating
between three displays: two
showing the selected program
and preview inputs and their
rates, and the third showing the
selected output rate.
2
sec.
2
sec.
Default Display Cycle
Extron
ISS 608
60-1684-01
FW Ver 1.00
Prog #01 HDMI
1080p @60Hz
720p @60 Hz
Prev #08 DP
Output Rate
1080p @60Hz
Power
on
Extron
Electronics
2
sec.
Front Panel Operations
ISS 608
INTEGRATION SEAMLESS SWITCHER
MUTE FREEZE
1 2 3 4 5 6 7 8
MUTE FREEZE
1 2 3 4 5 6 7 8
DISSOLVE
PIP
WIPE
CUT
LOGO
VIDEO
KEY
TAKE
ENTER
RECALL
SAVE
SIZE
POSITION
MENU NEXT
PROGRAM EFFECTS PRESETS ADJUST
TAKE
PREVIEW
CONFIG
ADJUST
H H F F D D G G C C B B E E A A
Figure 4. ISS 608 and ISS 612 Front Panels
A MUTE and FREEZE buttons C Effects buttons E Adjust buttons G Menu navigation controls
B Input selection buttons D Presets and TAKE buttons F USB Config port H LCD screen
Select an Input
Press and release the desired PROGRAM or PREVIEW input selection button (see figure 4,
B
). The button lights and the selected
input displays on the program or preview monitor. Press the MUTE or FREEZE buttons (
A
) to mute or freeze the PROGRAM or
PREVIEW output video.
4