Extron electronics ISM 824, Руководство пользователя

Страница: 71 / 166

3-39
ISM 824 Integration Scaling Multiswitcher • Operation and Setup
4 . Press Next to enter the next submenu, Sync Polarity. Within this submenu,
the Sync Polarity can be set (H- V-, H+ V-, H+ V+, or H- V+).
Rotate either front panel encoder to select the output signal type.
5 . Press Next to return to the Output Config. menu.
User Presets
Within this submenu, up to 3 presets can be saved or erased.
1 . From the Output Config. menu, press Menu to enter the User Presets menu.
2 . Press Next to go to the Save Preset menu.
Rotate either front panel encoder to select the preset
(1, 2, or 3) to save the current settings. Default setting is N/A.
3 . Press Next to go to the Save Preset menu.
Rotate either front panel encoder to select the preset to be erased
(1, 2, or 3) Default setting is N/A.
4 . Press Next to return to the User Preset menu.
N
Press Menu to go directly to the next top level menu (Advanced Config).
Recall a User Preset
1 . Press the Esc button to clear all active menus and reset the LCD to default
menu cycle.
2 . Make an input tie to the desired scaler output to recall any one of the three
saved presets, numbered 1 to 3.
3 . Press the output button. The LCD displays the message shown below.
Output Recalls
User Preset
4 . Press the output button to cycle through the saved output presets (1 to 3).
User Preset #2
Recalled
5 . If no presets were saved previously, the following message is displayed.
No Valid User
Presets Found
Advanced Config
Within this submenu auto imaging can be turned on or off, top and bottom
blanking area can be adjusted, and edge smoothing filter can be selected. In
addition blue mode, auto memory, 2:2 pull down, and enhanced mode can all be
turned on or off separately.
1 . From the User Presets menu, press Menu to for the Advanced Config.
submenu.
2. Press Next to go to the Auto Image menu. Auto Image can be turned on or off
for any input from this menu. Default setting is off.
Rotate the left front panel encoder (
[
) to select an input, or press the desired
input button. Rotate the right encoder (
{
) to turn Auto image on or off.