Extron electronics IPL Pro S1, Руководство пользователя

Страница: 18 / 39

IPL Pro Series • Hardware Features and Installation 12
Power Connections
A
Power input connector (external power supply) — Connect the IPL to the
included 12 VDC power supply here, then connect the external power supply to a
100 to 240 VAC power source.
POWER
12V
X.XA MAX
R
Ground
all devices.
External
Power Supply
(12 VDC, 1 A max.)
– Return
+12 VDC input
Ridged
Ridged
Smooth
Smooth
1A MA
X
100-240V 50-60Hz
Tie Wrap
3/16"
(5 mm)
Max.
Rear
Panel
Front Panel
NOTE: Check the
polarity of the
power supply
before connecting
it to the IPL.
Power Input, External Power Supply
• Front panel LED ( ) blinks during
boot-up and lights when the IPL is
powered and operational.
• Connect to
included 12 VDC
power supply.
Figure 7. Connecting an External Power Supply
ATTENTION:
•
Always use a power supply supplied or specified by Extron. Use of an unauthorized
power supply voids all regulatory compliance certification and may cause damage to
the supply and the unit.
•
Utilisez toujours une source d’alimentation fournie par Extron.
L’utilisation d’une source d’alimentation non autorisée annule toute conformité
réglementaire et peut endommager la source d’alimentation ainsi que l’unité.
•
Unless otherwise stated, the AC/DC adapters are not suitable for use in air handling
spaces or in wall cavities.
•
Sauf mention contraire, les adaptateurs AC/DC ne sont pas appropriés pour une
utilisation dans les espaces d’aération ou dans les cavités murales.
•
The installation must always be in accordance with the applicable provisions of
National Electrical Code ANSI/NFPA 70, article 725 and the Canadian Electrical
Code part 1, section 16. The power supply shall not be permanently fixed to building
structure or similar structure.
•
Cette installation doit toujours être en accord avec les mesures qui s’applique au
National Electrical Code ANSI/NFPA 70, article 725, et au Canadian Electrical Code,
partie 1, section 16. La source d’alimentation ne devra pas être fixée de façon
permanente à une structure de bâtiment ou à une structure similaire.
NOTE: — The IPL Pro Series control processors accept power over Ethernet (PoE)
through the LAN/PoE port (
C
) in addition to network communication (see
page 14 for cabling and details ). Both an external power supply and PoE can
be connected to the control processor simultaneously. The IPL uses PoE when it
is available but can switch seamlessly to the external 12 VDC power supply if the
PoE connection is dropped.
PRELIMINARY