Software-based Confi guration and Control, cont’d
DVCM 50 • Software-based Confi guration and Control
5-14
PRELIMINAR
Y
3
.
In the Switch Mode fi eld, select the Macro radio button.
Switch Mode fi eld with Macro selected
Performing IR Learning via software
The DVCM 50 can “learn” commands from your VCR or DVD player’s remote
control in order to control the VCR or DVD player. Using IR Learning, you can
program command codes to each of the DVCM button’s four memory blocks.
N
Buttons must be confi gures with IR commands before they are placed in macro
mode.
Follow these steps to initiate IR Learning via the confi guration program:
1
. Set
confi guration DIP switch #1 on the DVCM rear panel to
On (up). See diagram at right.
2
.
Launch the DVCM 50 confi guration software.
3
.
On the DVCM 50 DVD or VCR diagram on the Controller
(MLC) Confi g. tab, select the button for which you want the
DVCM to learn IR codes.
4
.
Select the Cmd radio button for the memory block where you want the
command to be stored.
1
ON
2 3 4
Содержание DVCM 50
Страница 1: ...DVCM 50 DVD VCR Control Module 68 1098 01 Rev A 11 05 ...
Страница 8: ...Introduction cont d DVCM 50 Introduction 1 4 PRELIMINARY ...
Страница 30: ...Configuration and Operation cont d DVCM 50 Configuration and Operation 3 14 PRELIMINARY ...
Страница 40: ...Special Application cont d DVCM 50 Special Application 4 10 PRELIMINARY ...
