Extron electronics DTP2 T 201 D, Руководство пользователя

Страница: 14 / 35

DTP2 T 201 D Transmitter • Installation and Operation 6
NOTES :
•
In order to fit in the wall box, the twisted pair cables and RJ-45 connectors
should not have a boot installed.
• One power supply can power both the transmitter and compatible receiver,
so only one unit needs a power supply (see
Power Supply Wiring on
page 11).
7. Trim back and insulate exposed cable shields with heat shrink to reduce the chance of
short circuits.
To prevent short circuits, the outer foil shield can be cut back to the point where the
cable exits the cable clamp.
8. Connect the cables to the rear of the unit.
9.
Connect front panel devices (see
Transmitter Front Panel
on the next page for
connector details), restore the power supply, and test the transmitter and receiver
system. Make cabling adjustments before final installation, as the cables are
inaccessible afterwards.
Mud Ring Installation
1. Using the mud ring as a guide, mark the edges and cut out the material within the
marked area.
2. Insert the mud ring into the opening and rotate and secure the locking arms with the
supplied screws shown (see figure 4).
Wall
Wall Mounting
Bracket
Figure 4. Installing the Mud Ring
3. Follow steps 6 through 9 of Site Preparation and Wall Box Installation starting on
page 4, and Final Installation on the next page.
4