6
68-2986-50 Rev. A
04 20
© 2020 Extron Electronics — All rights reserved.
All trademarks mentioned are the property of their respective owners.
For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics, see the
Extron Safety and Regulatory Compliance Guide
on the Extron website.
ATTENTION:
•
Do not connect this device to a computer data or telecommunications network.
•
Ne connectez pas cet appareil à un réseau de télécommunications ou de données informatiques.
•
Do not use Extron UTP23SF-4 Enhanced Skew-Free AV UTP cable or STP201 cable to link the matrix switcher to Extron DTP
products, XTP matrix switchers, or HDBaseT-enabled devices.
•
N'utilisez pas le câble AV Skew-Free UTP version améliorée UTP23SF-4 ou le câble STP201 pour relier la grille de commutation à
des produits DTP, à des grilles de commutation XTP ou à des appareils équipés HDBaseT Extron.
•
To ensure FCC Class A and CE compliance, STP cables and STP connectors are required.
•
Afin de s’assurer de la compatibilité entre FCC Classe A et CE, les câbles STP et les connecteurs STP sont nécessaires.
Analog audio output connector
Figure 5 shows how to wire the audio output connector. Use the supplied tie-wrap to strap the cable to the extended tail of the connector.
Unbalanced Stereo Output
Balanced Stereo Output
Do not tin the wires!
Tip
No Ground Here
No Ground Here
Tip
LR
Sleeves
Tip
Ring
Tip
Ring
LR
Sleeves
Figure 5.
Audio Output Connector Wiring
ATTENTION:
•
For unbalanced audio, connect the sleeves to the ground contact.
DO NOT
connect the sleeves to the negative (-) contacts.
•
Pour l’audio asymétrique, connectez les manchons au contact au sol.
Ne PAS
connecter les manchons aux contacts négatifs (–).
NOTES:
•
The length of exposed wires is important. The ideal length is 3/16 inch (5 mm).
•
If the stripped section of wire is longer than 3/16 inch, the exposed wires may touch, causing a short circuit.
•
If the stripped section of wire is shorter than 3/16 inch, wires can be easily pulled out even if tightly fastened.
•
Do not tin the leads. Tinned wires are not as secure in the connector and could be pulled out.
RS-232 and IR connectors
Figure 6 shows how to wire the RS-232 and IR connectors.
Tx/Rx
Pins
Rx Tx
Tx Rx
Gnd
Gnd
RS-232 Device
IR Device
RS-232 IR
Tx
Rx
Tx
Rx
G
Tx
Gnd
RS-232 Device
Rx
OVER TP
Rx
G
Tx
RS-23
2
DISPLA
Y
Tx
Gnd
RS-232 Device
Rx
Rx
G
Tx
RS-23
2
Figure 6.
RS-232 and IR Connector Wiring
NOTE:
The length of exposed wires is important (see the audio connectors
above for more information).
1
