1
IMPO
RTAN
T:
IMPO
RTAN
T:
Go to www
.extron.com f
or the complete
user guide
, installation instructions,
and
specifications bef
ore connecting the
product to the po
wer sour
ce.
DTP2 R 212 Series • Setup Guide
This guide provides instructions for an experienced installer to install, set up, and operate the following Extron DTP2 R 212 Series twisted
pair (TP) switching receivers:
•
DTP2 R 212
— Twisted pair receiver with a range of up 330 feet (100 M) from the transmitter
•
DTP2 R 212 SA
— Twisted pair receiver with a range of up 330 feet (100 M) and a built-in audio amplifier
NOTE:
For more information on any subject in this guide, see the
DTP2 R 212 Series User Guide
.
The receivers switch between a local HDMI input and a TP signal from a compatible DTP transmitter. The switching receivers are
compatible with all Extron DTP2 and legacy DTP products. The receiver and a compatible transmitter are rated for a range of up to
330 feet (100 M).
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources and mount the DTP2 R 212 Series as required.
Step 2 — Connections and Settings
Rear panel
NOTE:
Figure 1 is a composite drawing showing the features of all models. Items
F
,
H
, and
I
are present on only one model.
CLASS 2
WIRING
4/8 OHM
L
R
HDMI
Rx G
Tx
RS-232
DISPLAY
POWER
12V
3.0 A MAX
RS-232
Rx
Tx
G
OUTPUT
C
V
G
10V 50mA
L
R
VOL
REMOTE
R
DTP2 R 212 SA
LAN
1
2
Rx G
Tx
HDMI
RS-232
IR
Rx
Tx
OVER DTP2
INPUTS
SIG
LINK
DTP2 IN
OFF
SEND POWER
A
B
C
L
G
H
J
I
E
D
F
K
M
N
*
*
*
*
DTP2 R 212 SA only
DTP2 R 212 only
Figure 1.
DTP2 R 212 SA and DTP2 R 212 Rear Panel
A
HDMI input 1
(see
page 3
)
A
HDMI input 1
—
Plug an HDMI digital video source into the switcher via this HDMI connector. This connector can also
1
accept DVI video with appropriate adapters. See
on page 7 to use the LockIt HDMI Cable Lacing
Bracket™ to secure the connector to the switcher.
NOTE:
The maximum HDMI cable length is 4.5 m (15 feet).
