DTP T EU 4K 331, DTP T EU 4K 231, DTP T MK 4K 331, and DTP T MK 4K 231 • Installation and Operation
13
Mounting an EU transmitter in a Raceway Using Spacers (Optional)
If the EU transmitter does not stay in place when installed in
Junction Box
Mounting Bracket
Spacer
Raceway
a cable raceway, this may be due to a gap between the
metal mounting bracket and the bezel frame. When this gap
exists, the tabs on the sides of the transmitter do not reach
the metal mounting bracket and the transmitter does not
snap completely into the mounting bracket.
You can fix this problem by installing a spacer (provided with
the EU transmitter) between the metal mounting bracket
and the rim of the junction box. This spacer is engraved
with the words “Optional Spacer” and “Place behind
bracket” and has a slightly larger center opening than the mounting bracket.
NOTE:
Do not attempt to use the spacer in place of the metal mounting bracket.
Because of its larger opening, the spacer cannot hold the EU transmitter in place.
To mount the transmitter EU to a raceway using the spacer:
1.
Disconnect power from all devices at the source.
2.
Mount the junction box in the raceway.
3.
Attach the spacer to the junction box using two of the included screws in the holes
at the sides of the spacer. Leave the screw heads protruding approximately 1/8 inch
(3.175 mm) from the surface of the spacer (see figure 7).
Cable Raceway
Junction Box
Bezel Frame
Metal Bracket
DTP T EU
Spacer
Figure 7.
Mounting the EU Transmitter Using a Spacer
4.
With the “Front” marking toward you (away from the spacer and junction box), place the
metal mounting bracket onto the spacer so that the screw heads pass through two of
the slotted holes in opposite sides of the bracket.
5.
Rotate the mounting bracket as necessary to ensure that the transmitter will be
positioned straight on the mounting surface and not skewed to either side.
6.
Tighten the screws to secure the bracket to the spacer.
7.
Pull the TP cable and optional power cable through the junction box and the plastic
bezel frame and connect them to the transmitter.
8.
Align the bezel frame with the metal mounting bracket on the mounting surface.
9.
Press the transmitter into the frame until the unit snaps into place.
