Operation, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • Operation
3-4
Definitions
The following terms, which apply to Extron matrix switchers, are used throughout
this manual:
Tie —
An input-to-output connection.
Set of ties —
An input tied to two or more outputs. (An output can never be tied
to more than one input.)
Configuration —
One or more ties or one or more sets of ties.
Current configuration —
The configuration that is currently active in the
switcher (also called configuration 0)
Global memory preset —
A configuration that has been stored. Up to 32 global
memory presets
can be stored in memory. Preset locations are assigned to
the input buttons and (where necessary) output buttons. Up to 20 or 32
(depending on the number of input and output buttons) presets can be
selected from the front panel for either saving or retrieving. When a preset
is retrieved from memory, it becomes the current configuration. All models
have 32 presets; on models with fewer than 32 input and output buttons,
preset numbers that are too high to be available from the front panel are still
accessible under RS-232/RS-422 or Ethernet control.
Room —
A subset of outputs that are logically related to each other, as
determined by the operator. The switchers support up to 10 rooms, each of
which can consist of from 1 to 16 outputs.
Room memory preset —
A configuration consisting of outputs in a single room
that has been stored. When a room preset is retrieved from memory, it
becomes the current configuration.
Input and output buttons
If the switcher has fewer inputs or outputs than input or output buttons, only
the buttons for which the switcher has an input or output perform the function
of selecting and identifying that input or output.
1
Input buttons —
The input buttons have two primary functions (•) and four
secondary (
❏
) functions:
•
Select an input.
•
Identify the selected input.
❏
(Input 1 only)
With the Output 1 button, select I/O Group mode. See I/O
grouping on page 3-21.
❏
Select a preset. See Using presets on page 3-27.
❏
(CrossPoint 450 Plus switchers, Input 1 through 10 only)
Display the
RGB delay. See Setting RGB delay (CrossPoint 450 Plus Switchers) on
page 3-25.
❏
(Audio models)
Display the output volume level. Viewing and adjusting
the output volume (audio models) on page 3-40.
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203