Cable Cubby
®
Products • Installation
2-11
3
.
Install a second stand-off, in accordance with steps
1
and
2
.
4
.
Slide the stand-offs back and forth in the horizontal slots to
position them so that the cables easily rise and lower but
do not fall below the stand-offs.
5
.
Tighten the Phillips head screws to lock the stand-offs into
position.
6
.
Install and position the third stand-off, in accordance with
steps
1
and
2
and
4
and
5
to secure the remaining cables.
Mountng the Cable Cubby
W
The flanged edges of the top of the surface enclosure
are sharp. Exercise caution when the cubby is not
installed in a table to prevent personal injury.
C
The flanged edges of the top of the cubby are
bevelled to an ultra-fine thickness of less than
0.04 (4/100)” (approximately 1 mm). These
edges are soft and can be easily nicked or bent.
Exercise caution when handling and mounting the
enclosure. Mishandling can damage the appearance
of the enclosure.
1
.
Cable Cubby 300, 600, and 800 —
If
screw clamps are installed, remove them
from both sides of the enclosure
(figure 2-7 on page 2-12).
N
Figure 2-7 shows the installation of
a Cable Cubby 300C. Cable Cubby
300S, 600, and 800 installations are similar.
2
.
Remove the plastic strips that protect the corners of the
enclosure and the plastic film on the finished surfaces. If
a sticky residue remains, remove it with an appropriate
metal cleaning product.
C
Do not use isopropyl alcohol or other solvents to
clean the Cable Cubby. Strong solvents will ruin
some finishes.
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
