Cable Cubby
®
Products • Installation
Installaton
2-2
Installaton Overvew
Install and set up the Cable Cubby enclosures as follows:
1
If you plan to use a mounting template that has not been
prepared, prepare the template. See Preparing the Routing
Template
, later in this chapter.
2
Cut a hole in the surface where the enclosure will be
installed. See Preparing the Table, later in this chapter.
3
Run all cables necessary to support the AC connector,
the cables stored in the cubby, and all planned AAP
connectors. Leave enough slack in the cables to connect or
route them before the cubby is installed in the table.
4
If applicable, install the power module. If your location
requires electrical conduit, install an Extron flexible
conduit kit. Refer to the Flexible Conduit Kit Installation
Guide
, Extron part #68-734-01.
5
Install all desired cables into the cable pass-through (split)
AAPs and install the AAPs into the Cable Cubby. See
Installing the Cables and AAPs
, later in this chapter.
6
If applicable, connect cables to the rear connectors on
the passive AAPs and install the AAPs in the cubby. See
Installing the AAPs
, later in this chapter.
7
Mount the Cable Cubby in the table. See Mounting the
Cable Cubby
, later in this chapter.
8
Peel the protective film from the top surface.
9
Connect the Cable Cubby power cord.
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203