AVT 100 • Operation
Operation, cont’d
AVT 100 • Operation
3-9
Buttons on the AVT 100 IR Remote Control
The following functions are available through the buttons on
the AVT 100 Remote Control.
CHANNEL
CHANNEL
TUNE
MUTE
AVT 100 REMOTE
PRESET
VIDEO
AUDIO
0
1
2
3
4
5
6
7
8
9
ENTER
SAVE
1
8
6
5
4
7
3
2
Buttons on the AVT 100 Remote Control
1
Channel selection (0 through 9)
— In tune mode, press these
number buttons to specify a channel number, then press Enter
to select it.
In preset mode, pressing these buttons also selects the channel
whose number(s) you pressed. The buttons do not select preset
numbers.
2
Channel up/down
— Press the up and down arrows on this
rocker button to increment and decrement the channel or preset
number.
In tune mode, pressing either part of this button displays the
adjacent channel number. If an Auto-Scan has been performed,
pressing the Channel button causes the display to cycle between
the channels that were set by the scan for the mode (TV or
cable) in which the scan was done. (In this case, the adjacent
channel may not be available for display.)
In Preset mode, the next or previous preset channel is displayed,
depending on which part of the button you pressed. The
AVT 100 briefly displays the preset number preceded by a “P,”
then it displays the channel number associated with that preset.
If no presets have been defined when the Channel button is
pressed, the display shows “P00,” then the channel number to
which the AVT 100 was set before entering preset mode.
N
The Channel up/down button applies to antenna (TV)
and cable modes. Use the DIP switch on the rear panel
to switch between these modes.
3
Video Mute
— Press this button to toggle video muting on and
off. When muting is on, video output is mute.
4
Audio Mute
— Press this button to toggle audio muting on and
off. When muting is on, audio output is mute.
5
Tune
— Press this button to switch to tune mode. In tune mode,
the Channel buttons switch between channel numbers.
6
Preset
— Press this button to switch to preset mode. In preset
mode, the Channel buttons switch between preset channels.
7
Save
— After keying in a preset number, press this button to
save the currently selected channel as a preset.
8
Enter
— After keying in a channel number, press this button to
switch to that channel.
Selecting a channel (tuning) using the IR remote
To select or change a channel using the AVT 100 IR Remote
Control,
1
.
Using the IR remote channel selection number buttons in
the same way you would use the number keys on a
calculator, enter the number of the desired channel.
Example:
To change to channel 105, press the buttons
numbered 1, then 0, then 5.
2
.
Press the Enter button to activate the channel change. If
the number you entered is a valid channel, the AVT 100
switches to it, and the number remains displayed on the
AVT 100 front panel.
If you enter an invalid (out of range) channel number, after
3 seconds the front panel display returns to the channel
number that was displayed previously and does not
change the channel.
3-8
