7
Step 8: Mounting the ACP 105 D
Prior to mounting:
1.
Feed all device cables through the wall or furniture.
NOTE:
If the unit is not installed in a mud ring, the plastic spacer must be installed. The spacer positions the unit to allow
the plastic faceplate to attach properly and securely.
2.
Ensure the cables are connected to the ACP 105 D rear panel.
To mount an ACP 105 D with a wall mounting bracket (mud
ring):
1.
Mark the position of the hole for the wallplate on desired
wall location. Use a level to ensure the hole is marked at the
correct angle.
2.
Use a drywall saw to cut the hole for the wallplate (see
1
in
the figure to the right).
3.
Insert the mounting bracket (mud ring) into the hole and use
a screw driver to turn and tighten the locking arms until they
clamp the mud ring to the mounting surface (
2
). Do not
overtighten.
4.
If not already done, set bus ID DIP switches so the panel has a
unique bus ID (
3
).
5.
Use the two provided screws to secure the metal mounting
plate to the mud ring (
4
).
6.
Use the other two provided screws to secure the plastic
faceplate to the metal mounting plate (
5
).
To mount an ACP 105 D with a junction box:
1.
Install the junction box following the instructions provided with
the chosen junction box. No junction box is included with the
ACP 105 D.
2.
Locate a suitable wall stud and mark the location of the hole on
the wall. Use a level to ensure the hole is marked at the correct
angle.
3.
Use a drywall saw to cut the hole. Follow the instructions of
the junction box manufacturer for the correct dimensions of the
hole. Use at least two screws or nails to secure the box to the
wall or stud. Follow steps 4 through 6 above to complete the
installation.
Wall
Wall Mounting
Bracket
Faceplate
ACP 105 D
SO
URCE
1
SO
URC
E 2
SO
URCE
3
SOU
RCE
5
SOU
RCE
4
1
1
2
2
3
3
4
4
5
5
Electrical
Junction
Box
ACP 105 D
3
3
4
4
SO
URCE
1
SOUR
CE
2
SOUR
CE
3
SO
URCE
5
SO
URCE
4
Faceplate
5
5