7
Routing and Connecting Cables
For cable pass-through applications,
allow at least 36 inches (0.9 m) of cable
loop for each cable.
Connect cables to the AV system
and connect the AC power cord.
Using zip ties, secure cables to the holes
on the bottom of the Cable Cubby.
1
2
3
NOTE:
Ensure that there is no tension on the power cable.
CAUTION:
Risk of Electric Shock
.
This equipment must be grounded.
ATTENTION :
Risque de choc électrique
.
Cet équipement doit être fixé au sol.
Installation Checklist
Planning (page 1)
Check with local and state regulations before starting the installation
Check all parts and equipment before installation
Determine number of enclosures to install
Preparing the Table (page 2)
Determine the best location for the enclosure
Verify sufficient space under furniture
Cut a hole in the table and pre-drill mounting holes (page 3)
Preparing the Cable Cubby (page 4)
If applicable, assemble enclosures
Assemble connectivity modules
Install the modules (page 5)
Mounting the Cable Cubby (page 5)
Mount the Cable Cubby under the table
Installing Retractors (page 6)
Remove Retractor screws for horizontal and angular mount applications
Install Retractors into the bracket
Routing and Connecting cables (page 7)
Dress cables under the table
Connect cables to the AV system
