•
T-bar width can be either 9/16” (15mm) or 15/16” (24mm).
•
T-bar bottom must be flat all the way across.
•
T-bar minimum base thickness: N/A; must be structurally sound.
•
T-bar maximum base thickness: 0.055”. Due to manufacturing variation some adaptors may be able
to accommodate up to 0.060”.
•
Ceiling tile may protrude up to 0.3" below the T-bar.
1 Attach the T-bar adaptor by lining up the small bends on the adaptor with the long raised parts on
the main bracket, pull up on the adaptor’s locking pin, and twist. Make sure the locking pin goes into
the locking pin hole on the main bracket and locks in place.
2 Slide the T-bar holder onto the T-bar and replace the tiles to hold the adaptor onto the T-bar.
3 Hold the AP and rock it back and forth to ensure that it is securely mounted.
4 Attach the Ethernet cable’s RJ45 connector to the LAN1 port.
Mounting the AP using the WS-MBI-DCFLUSH Bracket to a Flat T-bar
The optional WS-MBI-DCFLUSH (#37211) bracket can also be used for T-bar installations without the
mounting bracket
•
T-bar width must be 9/16” (15mm), 15/16” (24mm), 1.5” (38mm).
•
T-bar bottom must be flat all the way across.
•
T-bar minimum base thickness: N/A; must be structurally sound.
•
T-bar maximum base thickness is 0.080” (2mm).
•
Ceiling tile must be flat all the way across.
•
Maximum ceiling tile protrusion allowed is 0.015” (0.38mm).
1 Remove the ceiling panels around the drop ceiling T-bar rail.
2 Open the movable sliding part of the bracket to give the stationary and slider T-bar more space.
Figure 11: Installing the WS-MBI-DCFLUSH bracket
Installation Process
ExtremeMobility™ AP510i FCC/WR Installation Guide
22
