Extreme Networks VSP 4900 Series, Руководство по установке оборудования

Страница: 49 / 78

9
Removing the Switch from the
Rack
To remove or reposition a switch after you have mounted it in a rack, follow these steps.
These procedures assume that you have attached the switch to the rack as described in Installing Your
Switch on page 35.
1 Disconnect the switch from its power source or sources.
2 Remove all cables and transceivers.
3 To remove a switch from a four-post rack, do the following:
a Release the tabs on both slider assemblies, and slide the switch away from the rear of the rack.
See Figure 20 .
Figure 20: Removing the Switch from the Slider Assemblies
b Disengage the retainers that are connecting the mounting brackets with the sliding rails on both
sides.
c Carefully slide the switch out of the slider assembly and place it on a flat surface.
You can leave the slider assemblies in place. If you want to remove them, continue with step 3.d .
VSP 4900 Series Switches: Hardware Installation Guide 49