Extreme Networks Summit Summit24, Инструкция по установке и эксплуатации

Страница: 116 / 244

116 Summit24e3 Switch Installation and User Guide
Network Address Translation (NAT)
This rule uses auto-constrain NAT. Remember that each inside IP address will be restricted in the
number of simultaneous connections. Most installations should use portmap mode.
Auto-Constrain Example
config nat add out_vlan_3 map source 192.168.3.0/24 to 216.52.8.64/32 both
auto-constrain
Advanced Rule Matching
By default, NAT rules only match connections based on the source IP address of the outgoing packets.
Using the
L4-port
and
destination
keywords, you can further limit the scope of the NAT rule so that
it only applied to specific TCP/UDP Layer 4 port numbers, or specific outside destination IP addresses.
NOTE
Once a single rule is matched, no other rules are processed.
Destination Specific NAT
config nat [add|delete] vlan <outside_vlan> map source [any | <ipaddress> [/<bits>|
<netmask>]] {destination <ipaddress/mask> } to <ipaddress> [/<mask> | <netmask> | -
<ipaddress>]
The addition of the
destination
optional keyword after the source IP address and mask allows the
NAT rule to be applied to only packets with a specific destination IP address.
L4-Port Specific NAT
The addition of the
L4-port
optional keyword after the source IP address and mask allows the NAT
rule to be applied to only packets with a specific L4 source or destination port. If you use the L4-port
command after the source IP/mask, the rule will only match if the port(s) specified are the source
L4-ports. If you use the L4-port command after the destination IP/mask, the rule will only match if the
port(s) specified are the destination L4-ports. Both options may be used together to further limit the
rule.
Configuring Timeouts
When an inside host initiates a session, a session table entry is created. Depending on the type of traffic
or the current TCP state, the table entries timeout after the configured timeout expires.
Table 28 describes the commands used to configure timeout periods.
Table 28: NAT Timeout Commands
Command Description
config nat finrst-timeout <seconds> Configures the timeout for a TCP session
that has been torn down or reset. The
default setting is 60 seconds.
config nat icmp-timeout <seconds> Configures the timeout for an ICMP packet.
The default setting is 3 seconds.