Extreme Networks ExtremeSwitching VDX 6740, Руководство по установке оборудования

Страница: 47 / 135

4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
FIGURE 27 Positioning the device in the rack
1. Screws, 10-32 x 5/8-in., panhead Phillips 2. Retainer nuts, 10-32
Attaching the rear brackets to the bracket extensions at the front of the
device
Complete the following steps to attach the rear brackets to the bracket extensions. There are short, medium, and long front brackets that
you can use for this step.
1. Select the proper length rear bracket for your rack depth.
2. Slide the right rear bracket onto the right extension, as shown in
Figure 28 .
The short rear brackets are shown. Use the first and third vertical pairs of holes for the screws.
Refer to Figure 29 for the positioning of the medium or long brackets and screws.
3. Attach the brackets using four 6-32 x 1/4-in. panhead screws.
4. Repeat
Step 2 and Step 3 to attach the left rear bracket to the left extension.
Flush-rear (recessed) mounting the device in the rack
ExtremeSwitching VDX 6740 Hardware Installation Guide
9036108-00 47