a. 10/1000BASE-T Gbps SFP28 Ethernet ports
b. 1000Gbps QSFP28 Ethernet ports
c. USB port
d. Console port RJ45
e. Management Set sliding button*
Figure 31: Port-side view of the SLX 9150-48XT Switch
Note
The console or serial port is intended primarily for the initial setting of the IP address.
3. Access the device using a terminal emulator application (such as HyperTerminal in a Windows
environment or Tip in a LINUX environment).
4. Disable any serial communication programs running on the workstation (such as synchronization
programs).
5. Open a terminal emulator application (such as HyperTerminal on a PC, or TERM, Tip, or Kermit in a
LINUX environment), and configure the application as follows:
•
In a Windows environment:
Parameter
Value
Bits per second
115200
Data bits
8
Parity
None
Stop bits
1
Flow control
None
Note
Flow control is not supported on the serial consoles when attached to remote terminal
servers and must be disabled to ensure proper operation.
•
In a LINUX environment, enter the following string at the prompt:
tip /dev/ttyb -115200
If ttyb is already in use, use ttya instead and enter the following string at the prompt:
tip /dev/ttya -115200
Activating and Verifying the Switch
Establishing a serial connection
ExtremeSwitching SLX 9150 Hardware Installation Guide
61
