Extreme Networks ExtremeMobility AP410i/e, Руководство по установке

Страница: 21 / 39

Callout Description
1 T-bar
2 Movable sliding part of the DCFLUSH bracket
3 Hook the stationary end of the bracket onto the T-bar.
4 Tilt the T-bar up slightly in such a way that you are holding the stationary and movable sides of the
bracket.
5 Squeeze the bracket parts together until you hear the T-bar locking tab click into place.
6 Slide the bracket base into the rear groove the access point.
7 Hold and rock the access point back and forth to ensure that it is securely mounted.
8 Attach the RJ45 connector to the GE1 port.
9 Replace the ceiling tiles.
Install the Access Point on a Flat T-bar Using the DCMTR01 Bracket
Ensure that the T-bar meets the following conditions before installing the DCMTR01 bracket on it:
•
T-bar width must be 9/16 in. (15 mm), 15/16 in. (24 mm), or 1.5 in. (38 mm).
•
T-bar must be structurally sound.
•
T-bar maximum base thickness cannot exceed 0.118 in. (3 mm).
•
T-bar maximum protrusion must be 0.625” (15.800 mm).
•
Maximum protrusion of the ceiling tile cannot exceed 0.625 in. (15.800 mm).
The optional WS-MBI-DCMTR01 (#30518) bracket is used for T-bar installations when the main
mounting bracket is not used.
1 Remove the ceiling panels around the T-bar.
Install the Access Point
ExtremeMobility™ Access Points AP410i/e 21