Installing the Engine into a Rack
13 of 31
to the installation guide for complete installation instructions.
If you are table mounting the engine, ensure at least 6 cm of clearance on all
sides of the engine for proper ventilation.
If you are installing the engine in a rack:
1. Install the rack handles by aligning a rack handle with the two holes on each side of
the engine and attaching each handle to the engine with two screws as shown
below.
Installing the Rack Handles
2. Read the installation guide included with the rack mounting kit.
3. Install the rails and mount the controller in the rack as instructed.
Torque Values
The following table describes the recommended torque values to use when
installing the engine using standard threaded fastener machine screws and
bolts.
Screw Size
Torque in Pounds
Bit Size
English
Metric
-%5
Nominal
+%5
N/A
N/A
1.42
1.5
1.57
0
Recommended Torque Values by Screw Size
