Extreme Networks AP60C, Руководство пользователя по оборудованию, Страница: 6 / 24

1. Disassemble the waterproof housing. There are four pieces: the sealing nut, the claw, a waterproof 2-part seal, and a threaded main hous-
ing body. Assemble these pieces around the Ethernet cable in the order shown here:
2. Insert the Ethernet cable through the sealing nut and claw.
3. Take the seal apart, insert the cable between the two halves and reassemble the seal.
4. Insert the seal into the claw.
5. Insert the Ethernet connector into the main body until the seal and claw fit snugly. Make sure that the small tabs on the claw fit into their
counterparts on the main body.
6. Screw the threaded nut onto the threaded housing until it is tight.
7. Insert the Ethernet cable into the female connector on the chassis. Rotate the head of the threaded housing clockwise until it locks into
place.
8. Connect the other end of the Ethernet cable to a PoE injector or PoE-enabled switch.
Accessories
The following accessories are available for the AP460C:
l
AH-ACC-PW-CBL-US : 6' 18 AWG universal power cord with US plug
l
AH-ACC-PW-CBL-UK : 6' universal power cord with UK plug
l
AH-ACC-PW-CBL-EU : 6' universal power cord with EU plug
l
AH-ACC-PW-CBL-AU : 6' universal power cord with AU plug
l
AH-ACC-PW-CBL-JP : 6' universal power cord with Japan plug
l
AH-ACC-PW-CBL- KR : 6' universal power cord with Korea plug
l
AH-ACC-BKT-ASM : Mounting bracket assembly for wall mounts. Attach this bracket to the back of the unit using the four holes in the chassis.
Remove the RJ45 Cable Safely
If you need to uninstall the device for any reason, for example for troubleshooting, you will need to remove the RJ45 cable. Use the following
steps:
1. For GE1 or GE2, loosen the gland sealing nut.
2. Move the gland cap, claw and seal down the cable at least 6 inches from the LAN connector.
3. Use a thin, strong non-conductive tool, such as a flat wooden stick to reach into the main gland body and depress the plastic locking latch
on the RJ45 connector.
Make sure not to touch any components of the PCBA board near the gland area.
5. While pressing down on the latch, gently pull on and remove the cable.
6. Remove the sealing nut, claw, and seal from the cable.
AP60C Hardware Guide 6
AP460C Hardware Guide 6