Extreme Networks AP60C, Руководство пользователя по оборудованию, Страница: 3 / 24

Mount the AP460C horizontally or vertically on a pole using the built-in brackets on the hardware, or on a solid flat surface using an accessory
bracket (see "Accessories "). These devices can be installed in even the most extreme outdoor environments. The following sections describe the
installation process.
Required Tools
To install your AP460C device horizontally or vertically on a pole, you will need the following items:
l
Two hose clamps that accommodate the diameter of the pole to which you are mounting the device.
l
A slotted screwdriver to tighten the hose clamps.
Install the Device
Before you install the device, make sure that you have all the materials and tools necessary, and familiarize yourself with the safety and site haz-
ard warnings.
For best performance, deploy AP460C devices in relatively open areas at least 100' (30.5 m) apart from each other.
Install the Device on a Vertical or Horizontal Pole
Use the following steps to install the device on a vertical or horizontal pole.
1. Thread two hose straps of the correct diameter for the pole through the slots in on the back of the device and around the pole. Hose straps
should be 1/2" (12 or 13 mm) wide and made of stainless steel.
2. While holding the device against the pole, use a slotted screwdriver to tighten first the top and then the bottom hose straps until the
device is secure. Make sure that the LAN glands are facing down (earth) to eliminate the chance of water entering the chassis. If you are
installing the device to sit on top of a horizontal pole, make sure the top of the device faces up (sky) with the LAN glands are protected by
the top.
AP60C Hardware Guide 3
AP460C Hardware Guide 3
Install the AP