Extreme Networks Altitude 3510, Руководство по установке

Страница: 16 / 46

Hardware Installation
Altitude 3510 Access Point Installation Guide
16
Wall Mounting
Wall mounting requires hanging the AP3510 along its width (or length) using the pair
of slots on the bottom of the unit and using the AP3510 itself as a mounting template
for the screws.
CAUTION
An AP3510 should be wall mounted to concrete or plaster-wall-board (dry wall) only. Do not wall
mount an AP3510 to combustible surfaces.
●
The mounting hardware and tools (customer provided) required to install the
AP3510 on a wall consists of:
●
Two Phillips pan head self-tapping screws
(ANSI Standard) #6-18 X 0.875in. Type A or AB Self-Tapping screw, or
(ANSI Standard Metric) M3.5 X 0.6 X 20mm Type D Self-Tapping screw
●
Two wall anchors
●
Security cable (optional)
To mount the AP3510 on a wall:
1 Orient the AP3510 on the or ceiling by its width or length.
2 Using the arrows on one edge of the case as guides, move the edge to the midline of
the mounting area and mark points on the midline for the screws.
3 At each point, drill a hole in the wall, insert an anchor, screw into the anchor the
wall mounting screw and stop when there is 1mm between the screw head and the
wall.
If pre-drilling a hole, the recommended hole size is 2.8mm (0.11in.) if the screws are
going directly into the wall and 6mm (0.23in.) if wall anchors are being used.
4
If required, install and attach a security cable to the AP3510 lock port.
5 Attach the Radio 1 and Radio 2 antennas to their correct connectors.
6 For information on the antennas available to the AP3510, see “ AP3510 Antenna
Options ” on page 12.
7 Place the large corner of each of the mount slots over the screw heads.
8 Slide the AP3510 down along the mounting surface to hang the mount slots on the
screw heads.