5
3.
Locate the composite aileron control horn, aileron pushrod with z-bend and ez-
connector. Remove the covering over the mounting hole for the control horn with
your #11 blade. Scuff the part of the control horn that will glue into the aileron
slot with fine sandpaper. Glue the control horn in place with medium CA.
Electronically center your servo and mount the ez-connector to the servo arm.
Place the z-bend in the aileron control horn and the other end of the wire into the
hole in the ez-connector. Center the aileron and tighten the screw in the top of the
ez-connector to retain the aileron pushrod wire. Use a small file to grind a flat
spot on the pushrod wire so that the set screw will seat properly and maintain a
firm grip on the pushrod wire. See picture.
