14
18.
Use a #11 blade to remove the covering from the slot near the bottom of the
rudder. Locate the composite control horn for the rudder. Scuff the control horn
to remove the glossy finish and glue into place in the slot in the rudder. Be sure
to center the horn in the slot. Attach the rudder to the fin with thin CA.
19.
Mount the rudder servo as shown inside the fuselage. Use the supplied hardware
to assemble the pull-pull cable system. At the rudder control horn end, the cable
will be threaded through the control horn and secured with a small aluminum tube
which is crimped around the cable as pictured in the photo above. At the servo
end, the cable is threaded through the hole in the connector as shown, secured
with a crimp and then inserted into the ez connector. Center the servo
electronically and make sure the rudder is in the neutral position. Tighten the
screw in the ez connector. Make sure the cables are taut, but not overly tight,
which may cause the servo to bind.
