Extreme Flight Turbo Bushmaster, Руководство пользователя, Страница: 8 / 27

8
9. Make sure the hinge can move freely and that the pin is aligned properly before the
epoxy sets! When you are satisfied with the results set the surface aside so that the
epoxy will pool around the rear of the hinge. When you are comfortable with this
process you should be able to do one side of a surface per batch of epoxy. Repeat the
process to attach the surfaces to each wing. There should be as little gap as possible
while still allowing maximum movement of the control surface.
10. As a final step before setting the wing aside to dry, do a final cleaning of the hinge
knuckles with a paper towel soaked with denatured alcohol or acetone to remove any
epoxy residue. If you find any of the hinges are stiff after drying, apply a drop of acetone
to each hinge with a Q-tip and move the surface back and forth several times to loosen it
up. As a final step I typically apply a couple drops of Teflon lubricant to each hinge. This
is available at most home improvement and hardware stores.
11. You will need to attach a 24 inch servo extension to your aileron servo to reach the
wing root. The flap servo wire will require a 6 inch extension. Secure the extensions to
the servo leads with heat shrink tubing or a servo wire safety clip .