Extreme Flight F3A, Инструкция по сборке

Страница: 42 / 48

Wing and stab incidence adjustment
35. Items needed are a level & Incidence meter. Install wings onto fuselage
with the carbon fiber tube. Do not use the wing hold down screws for this
adjustment. Place level on the flat area of the canopy fuse base. Level your
plane so that bubble is centered as shown.
36. Place your incidence meter onto each stab half and using adjuster screws
adjust each stab to read 0 (zero) degrees as shown. Remember the stab
adjuster screws are set against the aluminum rod. These set screws do not
require a lot of torque. Make sure to apply a drop of blue Loctite to these
screws.
37. Now place your incidence meter on your each wing half. With level bubble
still centered adjust wing incidence to read .3 (tenths of one degree) Positive.
(Leading edge UP). Once you have one wing half adjusted tighten the screws
on the wing adjuster plates & recheck your work. Repeat on other side.
Remember to have the fuselage completely level (bubble centered) during all
adjustments. This may take a few attempts to get correct but the reward is a
true flying airplane.