Extreme Flight F3A, Инструкция по сборке

Страница: 15 / 48

13
.
Seal the bottom of the hinge gap with a strip of Ultracote or Blenderm
tape. Be sure to fully deflect the control surface when applying the tape or
Ultracote to allow full deflection once the gap is sealed. Repeat this process
for the other stab/elevator assembly. Before you set aside the stabs take a
moment with your covering iron and go over all of the seams with a medium
heat setting, paying special attention to the ends of thin trim stripes. At this
point clean the 2 elevator/stab assemblies with Windex and set them aside.