Assemble the two units to the point where 3 walls and
all the corner supports are in position, referring to the
assembly instructions.
STEP
1
Assembly Instructions
This linking kit is suitable for linking Expandacom units and the range of Expandakabin units.
For illustrative purposes, the images show x2 Expandakabin 3m units being linked side to side.
Please refer to the instruction manual for each unit prior to commencing assembly.
NOTE: These instructions describe 2 units being linked when they have been constructed. However, in some
instances, it may be easier to assemble the first unit (omitting the wall panel where it will be linked) then
positioning the floor chassis of the second unit in place. Installation of the linking kit can then be carried out
and the wall panels for the second unit can be installed afterwards.
Either way, the following instructions will describe assembly of the linking kit.
Manoeuvre the chassis for the second unit in position,
adjacent to the first unit. Leave a gap between the units
as per the table below. You can gauge this by using the
bottom of the side linking panel which should fit snugly
between the 2 units.
STEP
2
Expandakabin
Expandacom
End to End
92mm
92mm
Side to Side
92mm
104mm
