Extraflame MARILENA PLUS, Руководство пользователя

Страница: 23 / 36

23 ENGLISH
Delta t
This function allows you to set the hysteresis to switch the stove on and off DELTA T , used as a room temperature adjustment interval if not
managed by an external thermostat. The exact temperature for ignition is SET THERMOSTAT - DELTA T . The temperature for switch-off is SET
THER DELTA T
.
The possible values for DELTA T go from: 0.5 - 5°C
CONTrOls prOCeDUre
Š press 6.
Š
press 3 until SETTingS appears and confirm by pressing 6.
Š
press 3 until DELTA T appears and confirm by pressing 6.
Š
Use keys 4 -5 to set the desired value.
Š
press 6 to confirm or 1 to return to the previous menus to the initial state.
FirST LoAD
This function allows to fill the auger, facilitating the first start-up phases of the stove, or in the event that the pellet hopper is empty. With the
stove cold and "OFF", make sure the pellet has been introduced inside the tank and activate the FirST LoAD function, confirming with OK.
To stop the continuous loading, simply press 1 for 3 seconds.
CONTrOls prOCeDUre
Š press 6.
Š
press 3 until SETTingS appears and confirm by pressing 6.
Š
Keep pressing 3 until FirST LoAD appears and confirm by pressing 6.
Š
Use keys 4-5 to enable "ON" / disable "OFF"
Š
press 1 several times to confirm and exit the menu.
J
for CorreCt operation, set the
SET room
THErmoSTAT to Low-TA
aDDitional therMostat
n.b. : the installation Must be perforMeD by an authoriseD teChniCian
There is a possibility to thermostat a room adjacent to the room where the stove has been placed; simply connect a thermostat following
the procedure described in the following section (it is advisable to place the optional mechanical thermostat at a heigh from the ground
equal to 1.50 m). stove operation with the external thermostat connected in the Ta terminal can be different depending on the activation or
deactivation of the sTaND-By function.
installation of aDDitional therMostat
Š Turn off the appliance via the main switch on the back of the
stove.
Š remove the plug from the power outlet.
Š Connect the two cables of the thermostat on the terminal (Ta)
behind the machine.
rESET
it allows you to bring all the values that can be changed by the user back to the factory settings.
CONTrOls prOCeDUre
Š
press 6.
Š press 3 until
SETTingS
appears and confirm by pressing 6.
Š Keep pressing 3 until
STAnD-BY
appears and confirm by pressing 6.
Š Use keys 4-5 to enable "ON" / disable "OFF"
Š press 1 several times to confirm and exit the menu.