s. 17
WARNING!
•
Turn the safety switch to
position “0” before you start
any maintenance work.
•
Shut off the supply of
pressurized air and drain the
pressure from the system
before you open the service
door.
•
Use safety goggles, a breathing
mask and safety gloves when
you carry out repairs or
maintenance work inside the
device.
•
Shut off the supply of
pressurized air and drain the
pressure from the system
before you open the service
door.
6.
Mount the
collecting bin.
* = ACCESSORY
EMPTYING THE COLLECTING BIN (WITH A CLOSING FLAP*)
•
All maintenance points must be
inspected regularly to ensure
that the suction unit operates as
planned.
•
The amount and composition of
the material filtered contribute
to the need for maintenance.
•
Any broken or worn parts must
be replaced with new ones.
1.
Open the
fastening
latches of the
tank.
2.
Empty the
collecting bin.
3.
Remove the
accumulated
dust from the
bottom section
of the cone and
check the
gasket.
4.
Make a hole
with a diameter
of approx. 15
mm
5.
Place the plastic
bag in the
collecting bin, so
that the hole
comes inside the
collecting bin.
After the collecting bin has become full, an indicator light on top of the display device will come
on. If the suction machine is equipped with a closing device in the collecting bin, the bin can be
emptied during use.
After emptying the bin
y
ou must confirm the procedure by pressing 'F4' to
open the seal.
It is possible to empty the collecting bin during use even if it is not full. You must first close the
seal of the collecting bin by pressing 'F1' on the display device and holding for four seconds; then
you can detach the collecting bin.
After emptying the bin
y
ou must confirm the procedure by
pressing 'F4' to open the seal.
