26
Assigning a Static IP Address
This section shows how to assign a static IP address using:
•
the Serial Admin interface (if you do not know the receiver’s IP address)
•
the receiver’s web interface (if you know the receiver’s IP address).
Using the Serial Admin Interface
Connect to the receiver as shown below.
1
2
Terminal Program
such as PuTTY.
Baud rate
: 115200
Data bits
: 8
Parity
: none
Stop bits
: 1
Flow control
: none
Admin
– log in using:
username:
admin
password:
labrador
to access the Serial Admin Interface.
Enter 4, then configure static IP address by
entering no for
Use DHCP?
Enter values
when prompted for IP address, gateway, and
subnet mask.
USB/Serial
Serial port (RJ45)
Exterity
access-usb
RJ-45 to USB
Exterity
access-srl
RJ-45 to DB9
Start terminal program
