14
5
months by cleaning each grill in a solution of mild non-
abrasive liquid detergent and water using a soft brush,
being careful not to apply too much pressure, which may
scratch the finish or bend the grill. Regular cleaning is
especially important in coastal areas.
Supports – Same as Grills above, but use only fresh water (no
detergent), being careful not to disturb the rubber gasket
installed on top side of supports, which are mounted with
waterproof adhesive.
Woofers – To maximize woofer/subwoofer driver life, gently wiping dirt
from the rubber surround with a soft damp cloth and
applying a coat of Armor All® protectant will help prevent
rot and extend life. It’s recommended that cleaning and
treatment take place each time the speaker grills are
removed for cleaning.
Tweeters – DO NOT attempt to clean.
NOTE!
Water should never be streamed directly into speaker
drivers for the purpose of cleaning.
Air Filter – Fan intake filter should be cleaned as needed by vacuum-
ing or gently washing.
5. From boxes with cabinets A,C remove the top four (4) foam corner
protectors and place in the up position on a solid surface. Next, move
each cabinet and place it face-up, with the back side resting on/in the
foam corner pieces as shown in
Fig. 3
.
6. From boxes with cabinets B,D remove the top four (4) foam corner
protectors and place two (2) in the up position on a solid surface.
Next, locate the four (4) small blue foam squares provided and place
two (2) for each cabinet as shown in
Fig. 4
. Finally, move each
cabinet and place it face-up, with the back side resting on/in the foam
corner pieces as shown in
Fig. 4
. This arrangement prevents
damage to the antenna on cabinet D and allows clearance for
installation of the Base Supports.
Note: Save (as many as possible) boxes/shipping materials for future
transport or shipment.
7. You are now ready to proceed to assembly and installation.
Assembly/Installation
1. Mount cabinet Base Supports to lower cabinets B and D.
1a. Locate four (4) aluminum Base Supports and eight (8) #10-32 x 1”
stainless machine screws.
1b. Using a phillips screwdriver, mount 2 ea. aluminum Base
Supports to the bottom of cabinets B and D with eight (8) #10-32
x 1” stainless machine screws.
NOTE!
Be careful not to over-tighten screws.
Fig. 3
Cabinets A ,C
Fig. 4
Cabinets B,D
Blue Foam
Model EA300SW-SA
TM
TM
Model EA300SW-SA
