9
10
S.
8. Install four (4) Speaker Grills on cabinets A,B,C, & D.
8a. Locate two (2) 14”x8” and two (2) 8”x 8” perforated aluminum
speaker grills and twenty (20) #6-32 x 5/32” stainless button
head cap screws.
8b. Install one (1) ea. speaker grill on cabinet A,B,C, & D using
provided 5/64” hex wrench and twenty (20) #6-32 x 5/32”
stainless button head cap screws. Install screws just enough to
catch the first few threads without fully tightening until all screws
are in place. Once all screws in place, snug screw heads to the
surface of the grill with light pressure.
NOTE!
Be very careful not to over-tighten screws.
8c. Carefully move assembled cabinets into final position. Using a
bubble level, adjust feet to level top or provide a slight slope to
the rear of the speaker cabinets to aid in water run-off, if direct
exposure to rain/snow is expected.
9. CONGRATULATIONS! Assembly is now complete and speakers are
ready to be connected.
Fig. 9
Safety Brackets
Install Here
Safety Bracket
Installed
Streaming Media Receiver/Speaker/Power Connections
Model EA300SW-SA speaker/stereo system is a “stand-alone” system,
which only requires wiring runs between the left and right speakers and
to a UL Approved 12vac-120W outdoor transformer as noted in
Fig. 10
.
Inputs for the Streaming Media Receiver and associated 5vdc power
output are also shown in Fig. 10.
It should be noted, external power to the integrated stereo is controlled
by a special sensor located in the stereo cabinet door. The door must be
opened in order to turn the system on initially, but may be opened and
closed thereafter without affecting stereo operation. This feature was
added to minimize power consumption.
NOTE!
The door should never be left open with the stereo power turned
off and the outdoor transformer on, or damage to the internal
power supply may result.
Right
Left
+
-
+
-
Fig. 10
+
-
+-
12vac-120W
UL Approved
Outdoor
Transformer
Connections
+
-
S. AUDIO IN
Streaming
Media
Receiver
Connections
Model EA300SW-SA
TM
TM
Model EA300SW-SA
