CHARACTERISTICS
Power supply:
12 V~ with the supplied transformer or 12 V with a DC
power supply (not provided)
Consumption:
50 mA in standby
Programming:
via the keypad front panel, memorised in the event of power
outage
Relay
(max. 1.5A, 12 V - 24 V): 1 relay: NO; NC; C terminals.
Time delay control: electric lock striker or lock, automatic opener, lighting…
On/Off Control: lighting…
Time delay:
relay with a duration of 1-99 seconds or On/Off function
SAFETY GUIDELINES
The transformer must always be mounted on the DIN track of a modular
board or projecting on a non-metal support using the two mounting holes. It
is understood that the terminal board covers must always be refitted and that
connection must be made to an electrical installation in compliance with the
NFC 15-100 standard for France ONLY ONCE THE WIRING HAS ALL BEEN
COMPLETED.
Protection:
The transformer is equipped with a “PTC” thermal cut-out. In
the event of damage or a short-circuit, the following steps should be taken to
restore transformer protection
1. Disconnect the 230V power supply (for at least 2 min.)
2. Repair as required
3. Reconnect the 230V power supply
New relay code
is saved
New default master code
is saved
press a new relay code
(4 - 8 digits)
by default = 12345678
+ press
press a new default master
code (4 - 8 digits)
by default = 8 x the digit 1
+ press
Instructions:
Enter your code and press , the relay will be operational for
the time you programmed.
If the relay is programmed in the On/Off mode, enter your code and press
, to switch it off, press , re-enter your code and press
#
.
press 56 + press
Default master code recording
press 51 + press
Recording relay code
English
