7
SDL550-EU-EN-V1.2-10/11
Setting the Datalogger Sampling Time (Rate)
1. Access the SP-t parameter.
2. Use the arrow buttons to select the desired sampling rate. The available settings are: 0, 1, 2, 5,
10, 30, 60, 120, 300, 600, 1800, and 3600 seconds.
3. Press the ENTER button to confirm the entry.
4. Press and hold the SET button for at least 1.5 seconds to exit to the normal operation mode.
Enabling/Disabling the Auto Power OFF Feature
1.
Access the PoFF parameter.
2.
Use the arrow buttons to select ON or OFF. With the Auto Power OFF feature enabled, the
meter will automatically switch OFF after 10 minutes of inactivity.
3.
Press ENTER to confirm setting.
4.
Press and hold the SET button for at least 1.5 seconds to exit to the normal operation mode.
Set the Beeper Sound ON or OFF
1.
Access the bEEP parameter.
2.
Use the arrow buttons to select ON or OFF.
3.
Press ENTER to confirm setting.
4.
Press and hold the SET button for at least 1.5 seconds to exit to the normal operation mode.
Numerical Format (comma or decimal)
European and USA numerical formats differ. The meter defaults to USA mode where a decimal
point is used to separate units from tenths, i.e. 20.00; The European format uses a comma, i.e.
20,00 to separate units from tenths. To change this setting:
1.
Access the dEC parameter.
2.
Use the arrow buttons to select USA or EUro.
3.
Press ENTER to confirm setting.
4.
Press and hold the SET button for at least 1.5 seconds to exit to the normal operation mode.
SD Card FORMATTING
1.
Access the Sd-F parameter.
2.
Use the arrow buttons to select YES to format the card (select NO to abort). Note that all data
on the card will be lost if formatting is attempted.
3.
Press ENTER to confirm selection.
4.
Press ENTER again to re-confirm.
5.
The meter will automatically return to the normal operating mode when formatting is complete.
If not, press and hold SET button for at least 1.5 seconds to exit to the normal operation mode.
Set the Temperature Units of Measure (°C or °F)
1.
Access the t-CF parameter.
2.
Use the arrow buttons to select °C or °F. Press ENTER to confirm setting.
3.
Press and hold the SET button for at least 1.5 seconds to exit to the normal operation mode.
