7 SDL400-en-GB_V1.6 12/14
Set the Temperature Units of Measure (C or F)
1. Access
the
t-CF
parameter as described in the Accessing Setup Mode section above.
2.
Use the arrow buttons to select the desired unit of measure.
3.
Press ENTER to confirm setting.
4.
Press and hold the SET button for at least 1.5 seconds to exit to the normal operation mode (or
simply wait 7 seconds for the meter to automatically switch to the normal operating mode).
Set the Thermocouple Type
(K or J)
1. Access
the
tYPE
parameter as described in the Accessing Setup Mode section above.
2.
Use the arrow buttons to select the desired sensor type.
3.
Press ENTER to confirm setting.
4.
Press and hold the SET button for at least 1.5 seconds to exit to the normal operation mode.
System Reset
If the meter’s keys become inoperable or if the display freezes the Reset button can be used to
reset the instrument.
Use a paper clip or similar item to momentarily press the reset button located on the lower right
side of the instrument under the snap-off compartment cover.
After pressing the Reset button, switch the instrument ON by pressing and holding the POWER
key for at least 1.5 seconds. If using the power adaptor unplug the adaptor and then plug it back
in again to power the meter.
Max-Min Reading Record and Recall
For a given measurement session, this meter can record the highest (MAX) and the lowest (MIN)
readings for later recall.
1.
Press the MAX-MIN button momentarily to access this mode of operation (REC icon appears)
2.
The meter is now recording the MAX and MIN readings.
3.
Press the MAX-MIN button again to view the current MAX readings (MAX icon appears). The
readings on the display are now the highest readings encountered since the REC icon was
switched on (when the MAX-MIN button was first pressed).
4.
Press the MAX-MIN button again to view the current MIN readings (MIN icon appears). The
readings on the display are now the lowest readings encountered since the REC icon was
switched on (when the MAX-MIN button was first pressed).
5.
To exit the MAX-MIN mode, press and hold the MAX-MIN button for at least 1.5 seconds. The
meter will beep, the REC-MAX-MIN icons will switch off, the MAX-MIN memory will clear, and
the meter will return to the normal operating mode.
