6 SDL400-en-GB_V1.6 12/14
Enabling/Disabling the Auto Power OFF Feature
1. Access
the
PoFF
parameter as described in the Accessing Setup Mode section above.
2.
Use the arrow buttons to select ON (enable) or OFF (disable). With the Auto Power OFF
feature enabled, the meter will automatically switch OFF after 5 minutes of inactivity.
3.
Press ENTER to confirm setting.
4.
Press and hold the SET button for at least 1.5 seconds to exit to the normal operation mode (or
simply wait 7 seconds for the meter to automatically switch to the normal operating mode).
Set the Beeper Sound ON or OFF
1. Access
the
bEEP
parameter as described in the Accessing Setup Mode section above.
2.
Use the arrow buttons to select ON (enable) or OFF (disable).
3.
Press ENTER to confirm setting.
4.
Press and hold the SET button for at least 1.5 seconds to exit to the normal operation mode (or
simply wait 7 seconds for the meter to automatically switch to the normal operating mode).
Numerical Format (comma or decimal)
European and USA numerical formats differ. The meter defaults to USA mode where a decimal
point is used to separate units from tenths, i.e.
20.00
; The European format uses a comma, i.e.
20,00
to separate units from tenths. To change this setting:
1. Access
the
dEC
parameter as described in the Accessing Setup Mode section above.
2.
Use the arrow buttons to select USA or EUro.
3.
Press ENTER to confirm setting.
4.
Press and hold the SET button for at least 1.5 seconds to exit to the normal operation mode (or
simply wait 7 seconds for the meter to automatically switch to the normal operating mode).
SD Card FORMATTING
1. Access
the
Sd-F
parameter as described in the Accessing Setup Mode section above.
2.
Use the arrow buttons to select YES to format the card (select NO to abort). Note that all data
on the card will be lost if formatting is attempted.
3.
Press ENTER to confirm selection.
4.
Press ENTER again to re-confirm.
5.
The meter will automatically return to the normal operating mode when formatting is complete.
If not, press and hold the SET button for at least 1.5 seconds to exit to the normal operation
mode.
