![background image](http://html1.mh-extra.com/html/extech-instruments/s3500t/s3500t_user-manual_2453645008.webp)
Page 8
1.4 Attaching Belt Loop System:
The belt loop system consists of two parts:
A knob located on the back part of the printer just above the battery door
A strap with click on connector
To attach the strap to the knob insert the knob located at the bottom of the printer
into the slot of the connector. Pull down until you hear a click. The printer is now
secure. The loop is then placed over your belt. Allow the printer to hang down to
either the left or right hip.
To release the printer, press in on the two latches on the connector and pull
the knob clear of the slot.
Note: Do not force or pull the printer from the connector without pressing
in on the two latches
2. Loading Supplies
2.1 Adding Paper/Labels:
The printer can print text, bar codes and graphics on thermal receipt paper. See
“Supply Specifications” for the width, thickness requirements and approved
vendors. Follow these steps to load printer paper.
Follow these steps to load printer paper:
Open the paper supply cover by placing your fingers under the “T” pull lever
and pulling up firmly on the supply cover until the lever stops moving.
DO NOT pull too hard. Use enough force to allow the cover to unlock and
lift freely
DO NOT force the “T” pull lever too far back
Place the paper supply roll into the paper supply well. Make sure the paper
supply unwinds from the bottom as shown in Figure 3
Position the paper supply between the print head guides
Make sure some supply (2-3 inches) extends beyond the top of the paper
supply well
Close the paper supply cover and press close.